Begin of the insertionWhen the statuses are created, they do not have any % Complete value by default. This makes the "% Complete by status" mode inoperant until the user manually and tediously sets the % Complete valuesEnd of the insertion Begin of the deletion See ##40867End of the deletion for Begin of the insertioneach status.

This work package sets default values forEnd of the insertion the Begin of the insertionseeded work package statusEnd of the insertion Begin of the deletion full picture.End of the deletion

* Begin of the insertionAddEnd of the insertion Begin of the deletion Change seeding to setEnd of the deletion % Complete values to Begin of the insertionseededEnd of the insertion Begin of the deletion createdEnd of the deletion statuses
* Begin of the insertionStandard editionEnd of the insertion Begin of the deletion Update closed statuses to always have 100%. This is consistent with previous behavior where all closed statuses (including rejected) is considered 100% complete in the computation.End of the deletion
* Begin of the insertionNew: 0%
* In specification: 10%
* Specified: 15%
* Confirmed: 20%
* To be scheduled: 25%
* Scheduled: 30%
* In progress: 50%
* Developed: 70%
* In testing: 80%
* Tested: 90%
* Test failed: 75%
* Closed:End of the insertion Begin of the deletion Is it desirable? Are there good reasons not to haveEnd of the deletion 100% Begin of the deletion completion for all closed statuses?End of the deletion
* Begin of the insertionOn hold: 30%
* Rejected: 0%
* BIM edition
* New: 0%
* In progress: 40%
* Resolved: 80%
* Closed: 100%End of the insertion Begin of the deletion we'll see later about how to exclude some statuses like rejectedEnd of the deletion