Content
View differences
Updated by Henriette Darge over 6 years ago
### **Steps to reproduce:**
1. Go to a board
2. Create a list with many WorkPackages
3. Drag a card
### **Actual Behavior**
* Currently the card itself is shown as a placeholder.
* Especially if the cards all look all quite similar it is hard to get which card is now positioned where (see picture)
* Users do not understand what order they will get when they release.
* When dragging to the very top or bottom there are small areas where the card is not dragged into the list any more. This is confusing, too.
### **Expected Behavior**
* Similar to the project overview page, the placeholder should have:
* no content
* a dotted border
* the same size as it will have once being dropped
* Behaviour at the very top and bottom should be more smooth and better visible what happens
1. Go to a board
2. Create a list with many WorkPackages
3. Drag a card
### **Actual Behavior**
* Currently the card itself is shown as a placeholder.
* Especially if the cards all look all quite similar it is hard to get which card is now positioned where (see picture)
* Users do not understand what order they will get when they release.
* When dragging to the very top or bottom there are small areas where the card is not dragged into the list any more. This is confusing, too.
### **Expected Behavior**
* Similar to the project overview page, the placeholder should have:
* no content
* a dotted border
* the same size as it will have once being dropped
* Behaviour at the very top and bottom should be more smooth and better visible what happens